DreamLine DL-6619C-07CL Guia de Instalação

Enigma-X Shower Door & Base Kit SHOWER Door AND SHOWER BASE KIT INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to al

“Enigma-X” Rev.2 Ver.5 08/2013 9 10. Upper guide rail (03) must be leveled horizontally. Adjust Guide rail bracket (08) using hex key on both end

“Enigma-X” Rev.2 Ver.5 08/2013 10 11. Parallel the Stationary glass (02) to the shower base or threshold. Measure the distance from the side wall

“Enigma-X” Rev.2 Ver.5 08/2013 11 13. Attach two Rollers (04) to the Glass door (05). Suspend the door by hanging the Rollers onto the Upper guid

“Enigma-X” Rev.2 Ver.5 08/2013 12 15. Apply Kitchen & Bath silicone at both ends of the Anti-splash threshold (15), around the Guide block (1

“Enigma-X” Rev.2 Ver.5 08/2013 13 Product Maintenance To ensure long lasting life for your acrylic back walls, wipe them off after each us

SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 2Preparation 1. Examine boxes and packages for shipping damage. Carefully remove Shower base from th

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 3SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 4Left-Hand Drain Configuration MODEL SPECIFICAT

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 5Right-Hand Drain Configuration

ENIGMA-X SHOWER DOOR & TUB DOOR INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 6NEO SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) DLT-2

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 7QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 8DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 9Left-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in) W1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 10Right-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 11Diagram of the Shower Base in a Cross Section Finished Wall Cement board S

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 12Shower Base Installation Preparation 1. Ensure that the floor and the studs are at right angle. Pr

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 132. Install the shower drain (NOT PROVIDED) according to the drain installation manual (supplied wit

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 15 6. After the bedding material has been poured and before it sets, place the shower base into the p

“Enigma-X” Rev.2 Ver.5 08/2013 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the n

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 16 Fig. 9 Product maintenance To insure long lasting life

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Doors please visit www.Bath

“Enigma-X” Rev.2 Ver.5 08/2013 3Detailed Diagram of Shower Door Components Packing List 01 Door stopper 2pcs 11 Hex wrench 3mm, 4mm, 5mm

“Enigma-X” Rev.2 Ver.5 08/2013 4Shower Door Installation 1. Measure the distance between two finished walls. This distance is marked as “W”. S

“Enigma-X” Rev.2 Ver.5 08/2013 5 3. Install the Upper guide rail (03) to the Stationary glass (02) with the Glass brackets (07) and tighten th

“Enigma-X” Rev.2 Ver.5 08/2013 6 4. Place the Stationary glass (02) on the preinstalled shower base or threshold and butt it up against the wall

“Enigma-X” Rev.2 Ver.5 08/2013 7 6. Drill the holes for the Wall bracket (19) using Ø 5/16 drill bit and insert the Wall anchors (9b). Drill the

“Enigma-X” Rev.2 Ver.5 08/2013 8 8. Place the Guide Block (12) on the shower base or the threshold and place the Stationary glass (02) back in t