DreamLine DL-6120C-01CL Guia de Instalação

Butterfly Shower Door, Base & Backwall Kit SHOWER Door, SHOWER BASE AND BACKWALLS KIT INSTALLATION INSTRUCTIONS STEP 1: Install Shower

“BUTTERFLY” Rev.3 Ver.3 03/2014 9 9. Locate the Guide rails (03) and the Glass profile (02). Connect the left end of the Gu

“BUTTERFLY” Rev.3 Ver.3 03/2014 10 10. Slide the pre-installed Door assembly 1 (as showing in Fig. 5) into the channel of the Guide rails (03)

“BUTTERFLY” Rev.3 Ver.3 03/2014 11 12. Slide the pre-installed Door assembly 2 (that showing on Fig. 10) into the channel of the Guide rai

“BUTTERFLY” Rev.3 Ver.3 03/2014 12 13. Attach the other Glass profile (02) at the right side of the door unit and fasten it to the Guide rails

“BUTTERFLY” Rev.3 Ver.3 03/2014 13 15. Attach the Roller stoppers (16) inside the top and the bottom Guide rails (03

“BUTTERFLY” Rev.3 Ver.3 03/2014 14 Shower Door Installation 16. The Tub or Shower base should be installed prior to installation. The Showe

“BUTTERFLY” Rev.3 Ver.3 03/2014 15 17. Push the Wall profiles (01) over the Glass

“BUTTERFLY” Rev.3 Ver.3 03/2014 16 18. Move the assembled Door unit on the Shower base or the Tub and butt the Wall profiles (01) up against th

“BUTTERFLY” Rev.3 Ver.3 03/2014 17 20. Make final adjustment if required. Drill the holes through the first layer into the Wall profiles (01) a

“BUTTERFLY” Rev.3 Ver.3 03/2014 18 22. Mount the Handles (17) onto the both Glass doors B & B2 (05). Cover the screw holes on the Handles

IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without prior notice. For the latest up-to-date technica

“BUTTERFLY” Rev.3 Ver.3 03/2014 1924. Apply silicone along the Wall profiles (01), as well as along the bottom Guide rail (03). See Fig

Ver. 1, Rev. 1 QWALL – 5.2 (2 Back Panels) SHOWER ACRYLIC WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify

Ver. 1, Rev. 1 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inclu

Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 10958"- 62"46"- 50"56784213 Packing List 01 Side panel 2pcs

Ver. 1, Rev. 1 4Preparation for Installation of Back Panel 1. Place a mark on the walls at a distance of 1” (one inch) from the corner and draw a p

Ver. 1, Rev. 1 5 3. Divide the measurement “W” by two and place a mark in the center of the back wall and from there draw a plumb vertical line from

Ver. 1, Rev. 1 6 5. Measure the Back Panel (09). Width of the Back Panel has to be less than or equal to the distance between the center line and the

Ver. 1, Rev. 1 7 7. Place the Back Panel (09) onto a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score al

Ver. 1, Rev. 1 8Preparation for Installation of Side Panels ATTENTION: See Fig. 9 for details. Fig. 9 8. Measure the side wa

Ver. 1, Rev. 1 9 9. Determine the position of both Side panels (01). NOTE: a) The narrow edge of the Side panel fits behind the corner cover and

“BUTTERFLY” Rev.3 Ver.3 03/2014 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of

Ver. 1, Rev. 1 10 Fig. 13 11. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the cor

Ver. 1, Rev. 1 11 12. Determine which Side panel (01) will be installed on the side wall with the fixture. Mark the fixture location on the Side panel

Ver. 1, Rev. 1 12Acrylic Back Panel and Side Panel Installation Instruction 14. Attach the Center cover (10) vertically at the center point along the

Ver. 1, Rev. 1 13 Fig. 19 16. Attach the Corner cover (02) to the corner of the shower and mark the drilling holes thro

Ver. 1, Rev. 1 14 Fig. 21 ATTENTION: 17. Apply the sealant to the entire surface of the reverse side of the Back panel (0

Ver. 1, Rev. 1 15 18. Slide the right edge of the left Back panel (09) all the way behind the Center cover (10) and push the Back panel against the wa

Ver. 1, Rev. 1 16 19. Mount the Corner cover (02) to the corner of the shower using the Countersunk screws ST4.2×30 (07). Do not fully tighten the scr

Ver. 1, Rev. 1 17 21. Slide the narrow edge of the Side panel (01) behind the Corner cover (02). Align trimmed edge of the Side panel (from Step. 9)

Ver. 1, Rev. 1 18 23. Once all panels are aligned, fasten tight the Corner cover (02) to secure the Side panels (01) and Back panels (09). Cover the s

Ver. 1, Rev. 1 19 ATTENTION; Prior to the next step, please be sure the part of the wall for installation of the Decorative edge molding (03) is clea

“BUTTERFLY” Rev.3 Ver.3 03/2014 3Detailed Diagrams of Shower Door Components B2AA2B876910234511121314151617181319 Packing List 01 Wall prof

Ver. 1, Rev. 1 20Glass Shelves Installation Instruction 27. Determine the desired height for the Glass shelves (05) and mark the locations on the wa

Ver. 1, Rev. 1 21 29. Mount the Shelf brackets (04) to the wall using the Countersunk screws ST4.2×30 (07). NOTE: the padded set screw of the Glass b

Ver. 1, Rev. 1 22 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a soft cloth. To

SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 2Preparation 1. Examine boxes and packages for shipping damage. Carefully remove Shower base from th

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 3SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 4Left-Hand Drain Configuration MODEL SPECIFICAT

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 5Right-Hand Drain Configuration

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 6NEO SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) DLT-2

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 7QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (

“BUTTERFLY” Rev.3 Ver.3 03/2014 4Shower Door Assembly Note: There are two separate Butterfly models featuring two different glass variations.

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 8DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 9Left-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in) W1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 10Right-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 11Diagram of the Shower Base in a Cross Section Finished Wall Cement board S

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 12Shower Base Installation Preparation 1. Ensure that the floor and the studs are at right angle. Pr

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 132. Install the shower drain (NOT PROVIDED) according to the drain installation manual (supplied wit

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 15 6. After the bedding material has been poured and before it sets, place the shower base into the p

“SLIMLINE SHOWER BASE” Rev.3 Ver.5 07/2013 16 Fig. 9 Product maintenance To insure long lasting life

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr

“BUTTERFLY” Rev.3 Ver.3 03/2014 5 2. Attach the top and the bottom Hinges (13) to the left edge of the Glass door A (04). Mind the position of

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Doors please visit www.Bath

“BUTTERFLY” Rev.3 Ver.3 03/2014 6 4. Connect the Glass door A (04) to the Glass door B (05) using the Middle hinges (11). Mind the position of

“BUTTERFLY” Rev.3 Ver.3 03/2014 7 5. Place the other Glass door B2 (05) and the other Glass door A2 (04) on a flat surface. The distances from

“BUTTERFLY” Rev.3 Ver.3 03/2014 8 7. Attach the top and the bottom Hinges (13) to the right edge of the Glass door A2 (04). Mind the position