DreamLine DL-6153-01CL Manual de Instruções

Prime Shower Enclosure, Base & Wall Kit SHOWER ENCLOSURE, SHOWER BASE AND BACKWALLS KIT INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserv

“PRIME” Enclosure Rev.1 Ver.1 05/2013 9 12. Apply the sealant along the profiles and guide rails; on the seams between the bottom guide rail and

SLIMLINE SHOWER BASE SHOWER BASE DIMENSIONS AND INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 2Preparation 1. Examine boxes and packages for shipping damage. Carefully remove Shower base from th

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 3SINGLE THRESHOLD SHOWER BASE Center Drain Configuration MODEL SPECIFICATION D (in) W (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 4Left-Hand Drain Configuration MODEL SPECIFICAT

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 5Right-Hand Drain Configuration

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 6NEO SHOWER BASE MODEL SPECIFICATION W (in) A (in) B (in) C (in) DLT-2

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 7QUARTER ROUND SHOWER BASE MODEL SPECIFICATION W (in) C (

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 8DOUBLE THRESHOLD SHOWER BASE Corner Drain Configuration MODEL SPECIFICATION W (in) C

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 9Left-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in) W1 (in)

PRIME SHOWER ENCLOSURE INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 10Right-Hand Drain Configuration MODEL SPECIFICATION D (in) W (in) D1 (in)

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 11Diagram of the Shower Base in a Cross Section Finished Wall Cement board S

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 12Shower Base Installation Preparation 1. Ensure that the floor and the studs are at right angle. Pr

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 132. Install the shower drain (NOT PROVIDED) according to the drain installation manual (supplied wit

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 14 4. Level the tray and place marks on the studs above the upper edge of the tile flange. See

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 15 6. After the bedding material has been poured and before it sets, place the shower base into the p

“SLIMLINE SHOWER BASE” Rev.3 Ver.4 05/2013 16 Fig. 9 Product maintenance To insure long lasting life

Ver. 1, Rev. 1 QWALL – 4 ACRYLIC SHOWER WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign produc

Ver. 1, Rev. 1 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inclu

Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 56784213 Packing List 01 Side panel 2pcs 05 Glass shelf 2pcs 02 Corner cover

“PRIME” Enclosure Rev.1 Ver.1 05/2013 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of

Ver. 1, Rev. 1 4Preparation for Installation of Side Panel ATTENTION: See Fig. 1 for details. Fig. 1 1. Place a mark on the

Ver. 1, Rev. 1 5 2. Measure the walls of the shower from the 1” (one inch) line in the corner (from Step. 1) to the points where you want Side panels

Ver. 1, Rev. 1 6 4. Place the Side panel (01) on a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score alon

Ver. 1, Rev. 1 7 5. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the corner of the shower to the fixture:

Ver. 1, Rev. 1 8 7. Drill the holes for the fixtures in the Side panel (01) using the proper diameter saw bit or a handheld jig saw. See Fig. 9 for

Ver. 1, Rev. 1 9 Fig. 11 9. Mount the Corner cover (02) to the corner of the shower using the Countersunk screws ST4.2×3

Ver. 1, Rev. 1 10 Fig. 13 10. Apply the sealant to the entire surface of the reverse side of the Side panel (01). Also, ap

Ver. 1, Rev. 1 11 11. Slide the narrow edge of the Side panel (01) behind the Corner cover (02). Align trimmed edge of the Side panel (from Step. 4) w

Ver. 1, Rev. 1 12 14. Once Side panels (01) aligned, fasten tight the Corner cover (02) to secure the Side panels. Cover the screw holes with the Dec

Ver. 1, Rev. 1 13 16. Apply caulk along the top edge of the Side panels (01) and along the connection of the bottom edges of the Side panels with the

“PRIME” Enclosure Rev.1 Ver.1 05/2013 3Detailed Diagram of Shower Enclosure Components 78910121314151116123 45617 Packing List 01 Wall profile

Ver. 1, Rev. 1 14 18. Mark the location for the Shelf brackets (04) according to the measurements in Fig. 20 and Fig. 21.1. Drill the holes using Ø5/1

Ver. 1, Rev. 1 15 Fig. 23 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off afte

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Bases ple

“PRIME” Enclosure Rev.1 Ver.1 05/2013 4Shower Enclosure Installation 1. Fasten the bottom Guide rail (03) to the Glass profiles (02) with the R

“PRIME” Enclosure Rev.1 Ver.1 05/2013 5 3. Slightly tap the Single side strips (09) in between the Stationary glasses (05) and the Glass profile

“PRIME” Enclosure Rev.1 Ver.1 05/2013 6 6. Move the finished frame to the designated position on the shower base, the bathtub or the threshold (

“PRIME” Enclosure Rev.1 Ver.1 05/2013 7 8. Fasten the top and the bottom Wheel assemblies (17) to the Glass door (04). The top wheels can adjust

“PRIME” Enclosure Rev.1 Ver.1 05/2013 8 10. Install the Handles (06) to the Glass doors (04). Press the Anti-water strips (08) on the vertical ed