DreamLine DL-6715-01CL Guia de Instalação

FLEX SHOWER ENCLOSURE INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time with

“FLEX” Enclosure Rev.1, Ver.3 03/2014 10 8. Extend width of the Door assembly (02) by stretching the top and bottom Expanding rails toward th

“FLEX” Enclosure Rev.1, Ver.3 03/2014 11 9. Make sure the Door assembly (02) is fully extended inside the Wall profile (01) and the Corner pr

“FLEX” Enclosure Rev.1, Ver.3 03/2014 12 11. Do the final adjustments to the Door assembly (02) and Return glass panel (09) if required. Open

“FLEX” Enclosure Rev.1, Ver.3 03/2014 13 13. Attach Flanged Anti-water strip (07) to the vertical edge of the Stationary glass. Cut Bottom A

“FLEX” Enclosure Rev.1, Ver.3 03/2014 14 Product Maintenance To ensure long lasting life for your acrylic back walls, wipe them off afte

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextends onlyto theoriginalowner/end‐userforhouseholduseonlyandisno

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Enclosure

“FLEX” Enclosure Rev.1, Ver.3 03/2014 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that al

“FLEX” Enclosure Rev.1, Ver.3 03/2014 3Detailed Diagram of Shower Enclosure Components 345678213911011 Door packing List 01 Wall profile 2pc

“FLEX” Enclosure Rev.1, Ver.3 03/2014 4Door Assembly Diagram Alluminum profileExpandable railExpandable railGlass doorStationary glassAllumin

“FLEX” Enclosure Rev.1, Ver.3 03/2014 5Shower Enclosure Installation NOTE: The installation of this shower enclosure requires two installers.

“FLEX” Enclosure Rev.1, Ver.3 03/2014 6 3. Trace the drilling holes on the wall through the predrilled holes in the Wall profile (01). Drill

“FLEX” Enclosure Rev.1, Ver.3 03/2014 7 5. Slide the Corner profile (10) over the aluminum vertical edge of the Re

“FLEX” Enclosure Rev.1, Ver.3 03/2014 8 6. Install the Handle (13) onto the Door assembly (02). Move the Door assembl

“FLEX” Enclosure Rev.1, Ver.3 03/2014 9 7. Slide the Return glass panel (09) assembly into the groove of the Return w